I have a Share Point Web Service that I want
to call in HTTPS from ABAP
in an ECC 6.0 SAP_BASIS 700 SP 30 system. The
following steps have been
executed:
BASIS work completed –
SAPCRYPTOLIB, HTTPS Activation, profile
parameters, STRUST certificates
I have created the Client Proxy in SE80 for the SharePoint WCF Web Service
The Logical Port was created in SOAMANAGER
The issue I have is when I test the process using SE80 sometimes it will prompt
for credentials, sometimes it won't. The behavior is very sporadic, I
can run it once and it prompts then the second time it doesn't. This is
especially true after a restart of the system. The user and password
are on the RFC destination under consumer security tab.
Any suggestions why the prompting for
credentials?
Regards
Diane Szmurlo